HART Data Collector SM100-M-8: 8-Channel HART to Modbus Converter from China Suppliers and Factory
Product Features
Eight HART devices can be connected simultaneously, and all HART channels set up for the HART data collector can be scanned both simultaneously and in parallel.
Three-terminal electromagnetic complete quarantine between the host power supply and HART channels. The two-wire interface is used by every channel. The HART module's electromagnetic quarantine voltage must be at least 1500 V. The ability to separate HART signals (4–20 ma) is supported.
Both RS485 and NET Ethernet interfaces must have a quarantine voltage of at least 1500 V.
Use a modular design that isolates the HART module from the host and allows for online HART module replacement in any channel.
An independent indicator light is supplied for each channel, indicating the communication status of the HART equipment and whether the equipment is online.
Equipped with a communication interface, operation/fault indicator light, etc.
Channel-wise data refresh rate ≥ 1 second.
Support RS485 and Ethernet interfaces with a minimum speed of 100 Mbps.
All HART devices' HART IDs can be read using proprietary HART commands.
Support Telnet remote settings, as well as configuration and operating modes.
Update firmware programs are supported.
As long as the loop resistance is less than or equal to 250 ohms, the equipment supports standard DIN rail mounting and has no effect on the accuracy or transmission of a 4–20 mA analog signal under normal, power failure, or fault conditions.
Field instruments are not powered by this equipment.
It is compatible with HART protocol Ver5.0 and higher.
Main Parameters
Frequently Asked Questions
Q: How many HART devices can this equipment connect to at the same time?
A: The equipment can connect to up to eight HART devices simultaneously. All HART channels configured for the data collector can be scanned both simultaneously and in parallel.
Q: What is the electromagnetic isolation voltage for the HART modules?
A: The equipment features a three-terminal electromagnetic complete quarantine between the host power supply and HART channels. The electromagnetic quarantine voltage for the HART module is at least 1500 V.
Q: Does this equipment support standard DIN rail mounting?
A: Yes, as long as the loop resistance is less than or equal to 250 ohms, standard DIN rail mounting is supported. This installation has no effect on the accuracy or transmission of the 4–20 mA analog signal under normal, power failure, or fault conditions.
Q: Can this equipment provide power to field instruments?
A: No, the field instruments are not powered by this equipment.
Q: What are the power supply and operating current requirements?
A: The required power supply voltage is DC 24V, and the operating current is less than 80mA.
Q: What is the operating temperature range for the device?
A: The device is designed to operate in temperatures ranging from -20°C to +75°C, with a workplace humidity range of 5% to 95% (without condensation).